Omron ZW Series User Manual page 158

Chapter 4
Settings for I/O
■ Setting the clamp value
If [Clamp] is selected for the processing when measurement cannot be performed, set
the clamp value to be output.
• For analog output
Output
When current is
output
When voltage is
output
• For binary output
MIN (-1048576)
MAX (1048575) (Default value)
As an example, here is an explanation of the procedure for setting the clamp value to
"analog voltage output 10 V".
Operating procedure
Steps
1 - 4 For moving to HLD.RST - CLAMP, see steps 1 to 4 in p.4-29
5
6
7
ZW
4-30
User's Manual
MIN (approximately 3.4 mA)/ 4 to 20mA (every 1 mA)/ MAX (approximately 21
mA), (Default value: MAX)
MIN (approximately -10.8 v)/ -10 to 10 V (every 1 V)/ MAX (approximately 10.8
V), (Default value: MAX)
Setting
Key operation Display
ZERORST/ ZERORST/ ESC ESC
ZERO/ SET ZERO/ SET
ZERORST/ ESC ZERORST/ ESC
ZERO/ SET ZERO/ SET
RUN RUN
H L
FUN FUN
L
TEACH TEACH
Setting
Press or keys to select either of "ANALOG"
and press key.
ZERO/ ZERO/ SET SET
Set the clamp value.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "10V" and press
RUN RUN
Press key for two seconds to enter the RUN
LIT
FUN FUN
L
TEACH TEACH
mode.
RUN RUN
Description
key.
ZERO/ SET ZERO/ SET