Omron ZW Series User Manual page 173

■ Task measurement result output
The following two output methods can be selected from.
• Measured value 1 mode (When measured values for multiple tasks are output
consecutively)
The preset tasks are output in order for each of a certain cycle.
• Measured value 2 mode (When measured values for multiple tasks are output by
BINARY_SEL input)
The tasks to output with binary output are selected with external input and the
measurement data for those tasks is output.
● Measured value 1 mode (When measured values for multiple tasks are output
consecutively)
Judgment output
(HIGH/PASS/LOW)
Binary output
TASK3 result
ON
GATE output
OFF
BINARY OUT output
010b
Item
T0 Measurement cycle
T4 GATE signal rise time
T5 Output time of GATE signal
T15 Binary output update cycle
T16 Binary output update cycle 2
• Explanation of operations (When the results for all tasks are output)
(1) The TASK1 results are output (judgment output and binary output).
(2) After the judgment result and binary data output, the GATE signal is turned ON.
(3) The GATE output time after the GATE signal is turned ON, the GATE signal is
turned OFF.
(4) After the binary output update cycle, the TASK2 results are output (judgment
output and binary output).
(5) After the binary output update cycle, the TASK3 results are output (judgment
output and binary output).
(1) (2) (3) (4)
T16
T15
T0 T4 T5
TASK4 result TASK1 result TASK2 result TASK3 result TASK4 result TASK1 result TASK2 result
011b 000b 001b
0.5 ms
-
Setting value
(0.1 to 100.0 ms)
T0uUpdate cycle
T0uUpdate cycleunumber of
tasks output
(5) (6) (7)
010b 011b 000b
Minimum
Depends on the set conditions
(0.5 to 30 ms)
0.2 ms
Setting value
(0.1 to 100.0 ms)
T0uUpdate cycle
T0uUpdate cycleunumber of
tasks output
Chapter 4
Timing Charts
TASK3 result
001b 010b
Maximum
ZW
4-45
User's Manual