Load control
This part contains the sections describing the functions for controlling and balancing network
load.
8.1
Dynamic MAC aging
The section describes commands with which the aging of dynamically learned entries is
configured in a MAC address list.
8.1.1
The "show" commands
This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
8.1.1.1
show mac-address-table aging-time
Description
To ensure that the address entries are up-to-date, MAC addresses are only kept in the
address table for a specified time.
This command shows the time after which the MAC addresses are removed from the
address table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
do [command]
[command]
or
cli#
you can execute the "show" commands in every
with the "show" command that you want to execute.
8
367