Siemens SINAMICS G120 Operating Instructions Manual page 267

Parameter
Table 6-38 Basic setup of motorized potentiometer
Parameter Description
p1035[0...n] BI: Motorized potentiometer
setpoint higher
p1036[0...n] BI: Motorized potentiometer
setpoint lower
p1040[0...n] Motorized potentiometer
start value [rpm]
p1047 MOP ramp-up time [s]
p1048 MOP ramp-down time [s]
r1050 Motorized potentiometer, set‐
point after the ramp-function
generator
p1070[0...n] CI: Main setpoint
p1071[0...n] CI: Main setpoint scaling
r1073 CO: Main setpoint active
p1075[0...n] CI: Supplementary setpoint
p1076[0...n] CI: Supplementary setpoint
scaling
Converter with the CU250S-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG
Setting
Signal source to continuously increase the setpoint
The factory setting depends on the inverter.
Inverters with PROFIBUS or PROFINET interface:
[0] 2090.13
[1] 0
Inverters without PROFIBUS or PROFINET interface: 0
Signal source to continuously decrease the setpoint
The factory setting depends on the inverter.
Inverters with PROFIBUS or PROFINET interface:
[0] 2090.14
[1] 0
Inverters without PROFIBUS or PROFINET interface: 0
Start value that is effective when the motor is switched on.
Factory setting: 0 rpm
MOP ramp-up time
Factory setting: 10 s
MOP ramp-down time:
Factory setting: 10 s
Motorized potentiometer, setpoint after the ramp-function generator
Signal source for the main setpoint
The factory setting depends on the Control Unit.
With PROFIBUS or PROFINET interface: [0] 2050[1]
Without PROFIBUS or PROFINET interface: [0] 755[0]
Signal source for scaling the main setpoint
Factory setting: 1
Displays the active main setpoint
Signal source for the supplementary setpoint
Factory setting: 0
Signal source for scaling the supplementary setpoint
Factory setting: 0
Advanced commissioning
6.18 Setpoints
265