Siemens SINAMICS G120 Operating Instructions Manual page 191

Bit
2
3
4
5
6
7
8
9
10
11
12
13
14
15
If you change over from another telegram to telegram 20, then the assignment of the previous
1)
telegram is kept.
Converter with the CU250S-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG
Significance
Telegram 20 All other tele‐
grams
1 = Operation enabled
1 = Fault active
1 = OFF2 inactive
1 = OFF3 inactive
1 = Switching on inhibited active
1 = Alarm active
1 = Speed deviation within the tol‐
erance range
1 = Master control requested
1 = Comparison speed reached or
exceeded
1 = current or 1 = torque limit
torque limit reached
reached
--- 1 = Holding
1)
brake open
0 = Alarm, motor overtemperature --
1 = Motor rotates clockwise
0 = Motor rotates counter-clock‐
wise
1 = CDS display 0 = Alarm, inver‐
ter thermal over‐
load
6.5 Drive control via PROFIBUS or PROFINET
Remarks
Motor follows setpoint. See control word 1,
bit 3.
The inverter has a fault. Acknowledge fault us‐
ing STW1.7.
Coast down to standstill is not active.
Quick stop is not active.
It is only possible to switch on the motor after
an OFF1 followed by ON.
Motor remains switched on; no acknowledge‐
ment is necessary.
Setpoint / actual value deviation within the tol‐
erance range.
The automation system is requested to accept
the inverter control.
Speed is greater than or equal to the corre‐
sponding maximum speed.
Comparison value for current or torque has
been reached or exceeded.
Signal to open and close a motor holding
brake.
Internal inverter actual value > 0
Internal inverter actual value < 0
Advanced commissioning
Signal inter‐
connection
in the inver‐
ter
p2080[2] =
r0899.2
p2080[3] =
r2139.3
p2080[4] =
r0899.4
p2080[5] =
r0899.5
p2080[6] =
r0899.6
p2080[7] =
r2139.7
p2080[8] =
r2197.7
p2080[9] =
r0899.9
p2080[10] =
r2199.1
p2080[11] =
r0056.13 /
r1407.7
p2080[12] =
r0899.12
p2080[13] =
r2135.14
p2080[14] =
r2197.3
p2080[15] =
r0836.0 /
r2135.15
189