Siemens SINAMICS G120 Operating Instructions Manual page 122

Low voltage inverters built-in units with cu250s-2 control units and encoder evaluation

Hide thumbs Also See for SINAMICS G120:

Table of Contents

4.5 Connecting the interfaces for the inverter control

Setting the bus address

1. Set the address using one of the subsequently listed options:

– Via the address switch

– On an operator panel via p0918

– With Startdrive

2. Switch off the inverter power supply.

3. Wait until all LEDs on the inverter are dark.

4. Switch on the inverter power supply again.

Your settings become effective after switching on.

The PROFIBUS address is set.

Overview of the interfaces on the front and upper side. (Page 92)

Confirm the prompt for saving your settings (copy RAM to ROM).

Converter with the CU250S-2 Control Units

Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG