Writing The License Key To The Card - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage inverters
built-in units with cu250s-2 control units and
encoder evaluation
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Appendix
A.2 Activating licensed functions
A.2.3
Writing the license key to the card
Overview
You write the license key to the memory card by writing the individual positions – in an
ascending order – into the bits of parameter p9920, and then subsequently activate the key
using p9921.
The procedure for Startdrive and BOP-2, based on the fictitious "E1MQ-4BEA" license key, is
described below.
Note
If you subsequently purchase an additional license, then you will require a new license key.
You must overwrite the old license key. The new license key can have more than 9 positions.
You must set p9920[0] = 0 in order to reset the license key.
Activating the license key with Startdrive
Procedure
1. Go online and switch over to the parameter view.
2. In the parameter view, go to parameter p9920
3. Enter the license key (example: "E1MQ-4BEA") - always use uppercase letters:
– p9920[0] = E
– p9920[1] = 1
– ...
– p9920[7] = E
– p9920[8] = A
4. Set p9921 = 1.
After activation, the inverter sets p9921 = 0.
You have activated the license key using Startdrive.
❒
496
Converter with the CU250S-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG
Advertisement
Table of Contents
