Assigning Of The Key Sources To Key Fill; (When The Key Source Auto Select Mode Is Selected); Setting Of The Switcher Input Signal - Sony HDS-7150 Installation Manual

HDS-7150
9-3. Set-up

9-3-6. Assigning of the Key Sources to Key Fill

(When the Key Source Auto Select Mode is Selected)

(1) In the set-up menu screen, press the keys on the display panel in the following sequence.
[5] (OPERATION), [F4] (AUTO SELECT)
The function key indications change as follows.
F1
(2) While pressing the [F3] (FILL) key, press the desired crosspoint button on the AUX bus block.
Or, while pressing the [F3] (FILL) key press the [(] or [)] key.
The key fill button to be set is selected.
(3) While pressing the [F6] (SOURCE) key, press the desired crosspoint button on the AUX bus block.
Or, while pressing the [F6] (SOURCE) key press the [(] or [)] key.
The key sources signal to be assigned to the key fill button selected at the step (2) is selected.
(4) Repeat the steps (2) and (3) to assign the key source signals to all key fill buttons.

9-3-7. Setting of the Switcher Input Signal

(1) In the set-up menu screen, press the keys on the display panel in the following sequence.
[2] (INPUT/OUTPUT), [F3] (SWER INPUT)
The function key indications change as follows.
BUTTON
No.
F1
(2) While pressing the [F1] (BUTTON No.) key, press the desired crosspoint button on the AUX bus
block. Or, while pressing the [F1] (BUTTON No.) key press the [(] or [)] key.
The crosspoint button to be set is selected.
(3) Press the [F5] (PHASE ADJUST) key. Adjust the H phase of the input using the knob (control
knob) 4.
(4) Repeat the steps (2) and (3) to set all input signals.
9-14
FILL SOURCE
F2 F3 F4 F5
PHASE
ADJUST
F2 F3 F4 F5
F9 F10
F6 F7 F8
F6 F7 F8 F9 F10
HDS-7150/7100