Comparison: Differences In Manual Operation, Operation; Comparison: Differences In Program Run, Operation - HEIDENHAIN TNC 620 User Manual

20
Comparison: Differences in Manual Operation,
operation
Function
Capturing the position values from
mechanical probes
Exiting the Touch Probe Functions
menu

Comparison: Differences in Program Run, operation

Function
Arrangement of soft-key rows and
soft keys within the rows
Operating mode switchover after
program run has been suspended
by switching to the Program run,
single block operating mode and
canceled with INTERNAL STOP
GOTO is used to go to FK
sequences after program run was
interrupted there before switching
the operating mode
Mid-program startup:
Switching the screen layout for mid-
program startup
Error messages
Point patterns in single block
828
Tables and Overviews | Functions of the TNC 620 and the iTNC 530 compared
TNC 620
Confirm actual position with a soft
key or hard key
Using the END soft key or the END
hard key
TNC 620
Arrangement of soft-key rows and soft-keys differs according to the
active screen layout.
When you return to the Program
run, full sequence mode: error
message Current block not
selected. Use mid-program startup
to select the point of interruption
Error message FK programming:
Undefined starting position
Entering with mid-program startup
is permitted
Only possible, if startup position
has already been approached
Error messages are still active after
the error has been corrected and
must be acknowledged separately
With point pattern cycles and CYCL
CALL PAT, the control stops after
each point.
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
iTNC 530
Actual-position capture by hard key
Using the END soft key or the END
hard key
iTNC 530
Switching the operating mode
is allowed, modal information is
saved, program run can be contin-
ued by pressing NC start
GOTO allowed
Possible in all operating states
Error messages are sometimes
acknowledged automatically after
the error has been corrected
Point pattern cycles and CYCL
CALL PAT are handled by the
control as a single block