HEIDENHAIN TNC 620 User Manual page 731

Test Run and Program Run | Program run
Block scan in a point table
If you start in a point table called by the main program, use the
ADVANCED soft key.
Press the BLOCK SCAN soft key
The control shows a pop-up window.
Press the ADVANCED soft key
The control expands the pop-up window.
Point number = enter the line number of the
point table you start with
Enter the Point file = name and path of the point
table
If required, press the SELECT LAST BLOCK soft
key in order to select the last saved interruption
Press the NC Start key
If you would like to start with the mid-program startup in a point
pattern, then proceed just as you would for starting in the point
table. Enter the desired point number in the Point number = input
field. The first point in the point pattern has the point number 0.
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
18
731