HEIDENHAIN TNC 620 User Manual page 781

Tables and Overviews | Machine-specific user parameters
Parameter settings
DisplaySettings
Behavior with control start-up
Acknowledge "Power interrupted" message
TRUE: Control start-up is not continued until the message has been acknowledged
FALSE: "Power interrupted" message not displayed
DisplaySettings
Display mode for time display
Selection for display mode in the time display
Analog
Digital
Logo
Analog and Logo
Digital and Logo
Analog on Logo
Digital on Logo
DisplaySettings
Link row On/Off
Display setting for link row
OFF: Deactivate the information line in the operating mode line
ON: Activate the information line in the operating mode line
DisplaySettings
Settings for 3-D display
Model type of 3-D display
3-D (compute-intensive): Model display for complex machining operations with
undercuts
2.5-D: Model display for 3-axis machining operations
No Model: Model display is disabled
Model quality of the 3-D display
very high: High resolution; Block end points can be displayed
high: High resolution
medium: Medium resolution
low: Low resolution
Reset tool paths in new BLK form
ON: With new BLK form in the test run, the tool paths are reset
OFF: With new BLK form in the test run, the tool paths are not reset
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
20
781