Reading System Data - HEIDENHAIN TNC 620 User Manual

10

Reading system data

With the function SYSSTR you can read system data and store
them in string parameters. You select the system data through a
group number (ID) and a number.
Entering IDX and DAT is not required.
Group name, ID no.
Program information, 10010
Channel data, 10025
Values programmed in the tool
call, 10060
Current system time, 10321
Touch-probe data, 10350
Data for pallet machining, 10510
NC software version, 10630
Tool data, 10950
448
Number Meaning
1 Path of the current main program or pallet program
Path of the cycle selected with CYCL DEF 12 PGM
3
CALL
Path of the program selected with SEL PGM
10
1 Channel name
1 Tool name
1 - 16
50 Probe type of the active touch probe TS
70 Probe type of the active touch probe TT
73 Key name of the active touch probe TT from MP
activeTT
1 Pallet name
2 Path of the selected pallet table
10 Version identifier of the NC software version
1 Tool name
2 DOC entry of the tool
4 Tool-carrier kinematics
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Programming Q Parameters | String parameters
1: DD.MM.YYYY hh:mm:ss
2 and 16: DD.MM.YYYY hh:mm
3: DD.MM.YY hh:mm
4: YYYY-MM-DD hh:mm:ss
5 and 6: YYYY-MM-DD hh:mm
7: YY-MM-DD hh:mm
8 and 9: DD.MM.YYYY
10: DD.MM.YY
11: YYYY-MM-DD
12: YY-MM-DD
13 and 14: hh:mm:ss
15: hh:mm