Tool Usage File; Select Kinematics - HEIDENHAIN TNC 620 User Manual

MOD Functions | Machine settings

Tool usage file

Refer to your machine manual.
The tool usage test function must be enabled by your
machine tool builder.
With the MOD function Tool-usage file, you can select whether
the control never, once, or always creates a tool usage file.
Generate a tool usage file:
In the MOD menu, select the Machine settings group
Select the Tool-usage file menu
Select the desired setting for the Program Run, Full Sequence/
Single Block and Test Run operating modes
Press the APPLY soft key
Press the OK soft key

Select kinematics

Refer to your machine manual.
Your machine tool builder configures and enables
theKinematics selection function.
Danger of collision!
All stored kinematics can also be selected as active machine
kinematics. By this means, all manual movements and
machining operations are executed using the selected
kinematics. All subsequent axis movements pose a risk of
collision!
Use the Kinematics selection function only in the Test Run
operating mode
Use the Kinematics selection function for selecting the
active machine kinematics only as needed
You can use this function to test programs whose kinematics
does not match the active machine kinematics. If your machine
manufacturer saved different kinematic configurations in your
machine, you can activate one of these kinematics configurations
with the MOD function. When you select a kinematics model for
the test run this does not affect machine kinematics.
Ensure that you have selected the correct kinematics
in the Test Run operating mode for checking your
workpiece.
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
NOTICE
19
745