HEIDENHAIN TNC 620 User Manual page 388

10
In the NC program, program FN 16: F-PRINT to activate the
output:
Enter the path of the source and the path of the output file in the
FN 16 function .
Specify the output file containing the output texts within the
function FN16. The control generates the output file at the end of
program (END PGM), at program abortion (NC-STOPP key) or via
M_CLOSE command.
If you only specify the file name as the path name of
the log file, then the control saves the log file in the
directory of the NC program with the FN16 function.
Program relative paths as an alternative to complete
paths:
Starting from the folder of the calling file one folder
level down FN 16: F-PRINT MASKE\MASKE1.A/
PROT\PROT1.TXT
Starting from the folder of calling file one folder level
up and in another folder FN 16: F-PRINT ..\MASKE
\MASKE1.A/ ..\PROT1.TXT
Example
96 FN 16: F-PRINT TNC:\MASK\MASK1.A/ TNC:\PROT1.TXT
The control then creates the file PROT1.TXT:
MEASURING LOG OF IMPELLER CENTER OF GRAVITY
DATE: July 15, 2015
TIME: 8:56:34 AM
NO. OF MEASURED VALUES : = 1
X1 = 149.360
Y1 = 25.509
Z1 = 37.000
388
Programming Q Parameters | Additional functions
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017