HEIDENHAIN TNC 620 User Manual page 398

10
Group Gruppen-
name nummerID
Values for LAC and VSC
71
Freely available memory area for OEM cycles
72
Freely available memory area for user cycles
73
Minimum spindle speed
90
Tool compensation
200
398
Systemdaten- Index
nummer
0 0
2
1 0
0-39 0 to 30
0-39 0 to 30
1 Spindle ID
1 1 = without
oversize 2 =
with oversize
3 = with
oversize and
oversize from
TOOL CALL
2 1 = without
oversize 2 =
with oversize
3 = with
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Programming Q Parameters | Additional functions
Description
Index of the NC axis for which the LAC
weighing run will be performed or was last
performed (X to W = 1 to 9)
Total inertia determined by the LAC weighing
run in [kgm 2 ] (with A/B/C rotary axes) or total
mass in [kg] (with X/Y/Z linear axes)
Cycle 957 Retraction from thread
Freely available memory area for OEM
cycles. The values are only reset by the
control during a control reboot (= 0).
With "Cancel," the values are not reset to
the value that they had at the time of execu-
tion.
Up to and including 597110-11: only NR 0-9
and IDX 0-9
Starting with 597110-12: NR 0-39 and IDX
0-30
Freely available memory area for user cycles
The values are only reset by the control
during a control reboot (= 0).
With "Cancel," the values are not reset to
the value that they had at the time of execu-
tion.
Up to and including 597110-11: only NR 0-9
and IDX 0-9
Starting with 597110-12: NR 0-39 and IDX
0-30
Minimum spindle speed of the lowest gear
range. If no gear ranges are configured, the
spindle speed is taken from the parameter
set with index 0.
Index 99 = active spindle
Active radius
Active length