HEIDENHAIN TNC 620 User Manual page 395

Programming Q Parameters | Additional functions
Group Gruppen-
name nummerID
Modal status
35
Data for SQL tables
40
Data from the tool table
50
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Systemdaten- Index
nummer
70 -
1 -
1 -
1 Tool no.
2 Tool no.
3 Tool no.
4 Tool no.
5 Tool no.
6 Tool no.
7 Tool no.
8 Tool no.
9 Tool no.
10 Tool no.
11 Tool no.
12 Tool no.
13 Tool no.
14 Tool no.
15 Tool no.
16 Tool no.
17 Tool no.
18 Tool no.
19 Tool no.
20 Tool no.
21 Tool no.
22 Tool no.
28 Tool no.
32 Tool no.
34 Tool no.
35 Tool no.
Description
Multiplier for feed rate (cycles 17 and 18)
Dimensions:
0 = absolute (G90)
1 = incremental (G91)
Result code for the last SQL command. If the
last result code was 1 (=error), the error code
is transferred as the return code.
Tool length L
Tool radius R
Tool radius R2
Oversize for tool length DL
Tool radius oversize DR
Tool radius oversize DR2
Tool locked TL
0 = not locked, 1 = locked
Number of the replacement tool RT
Maximum tool age TIME1
Maximum tool age TIME2
Current tool age CUR.TIME
PLC status
Maximum tooth length LCUTS
Maximum plunge angle ANGLE
TT: Number of tool teeth CUT
TT: Wear tolerance for length, LTOL
TT: Wear tolerance for radius, RTOL
TT: Direction of rotation DIRECT
0 = positive, –1 = negative
TT: Offset in plane R-OFFS
R = 99999.9999
TT: Offset in length L-OFFS
TT: Breakage tolerance for length, LBREAK
TT: Breakage tolerance for radius, RBREAK
Maximum speed NMAX
Point angle TANGLE
LIFTOFF allowed
(0 = No, 1 = Yes)
Wear tolerance for radius R2TOL
10
395