HEIDENHAIN TNC 620 User Manual page 631

Manual Operation and Setup | Moving the machine axes
Caution: Danger to the tool and workpiece!
The wireless handwheel triggers an emergency stop reaction
if the radio transmission is interrupted, the battery is fully
empty, or if there is a defect. Emergency stop reactions during
machining can cause damage to the tool or workpiece.
Place the handwheel in the handwheel holder when it is not
in use
Keep the distance between the handwheel and the
handwheel holder small (pay attention to the vibration alarm)
Test the handwheel before machining
If the control has triggered an emergency stop you must reactivate
the handwheel. Proceed as follows:
Press the MOD key to select the MOD function
Select Machine settings
Press the SET UP WIRELESS HANDWHEEL soft
key
Click the Start handwheel button to reactivate
the wireless handwheel
To save the configuration and exit the
configuration menu, press END
The MOD operating mode includes a function for commissioning
and configuring the handwheel.
Further information: "Configuring the HR 550FS wireless
handwheel", page 770
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
NOTICE
16
631