HEIDENHAIN TNC 620 User Manual page 786

20
Parameter settings
Do not display
Behavior of M7 and M8 with cycles 202 and 204
Do not show
Geometry filter for filtering out linear elements
CfgThreadSpindle
786
0: Function inactive
1 to 999: Number of M function for spindle orientation
"Plunging type not possible
on: Error message is not displayed
off: Error message is displayed
TRUE: At the end of cycle 202 and 204 the condition of M7 and M8 is restored
before the cycle call
FALSE: At the end of cycle 202 and 204 the condition of M7 and M8 is not
restored independently
Remaining material
on: Warning is not displayed
off: Warning is displayed
Type of stretch filter
- Off: No filter active
- ShortCut: Leave out single points on polygon
- Average: The geometry filter smooths corners
Maximum distance of filtered to unfiltered contour
0 to 10 [mm]: The filtered out points lie within this tolerance to the resul-
tant distance
Maximum length of distance resulting from filtering
0 to 1000 [mm]: Length over which geometry filtering is effective
Potentiometer for feed rate during thread cutting
SpindlePotentiometer: During thread cutting, the potentiometer for shaft
speed override is effective. The potentiometer for feed rate override is not
active
FeedPotentiometer: During thread cutting, the potentiometer for feed
rate override is effective. The potentiometer for shaft speed override is
not active
Waiting time at reversal point in thread base
–999999999 to 999999999: The spindle stops for this time at the bottom
of the thread before starting again in the opposite direction of rotation
Advanced switching time of spindle
–999999999 to 999999999: The spindle is stopped at this time before
reaching the bottom of the thread
Tables and Overviews | Machine-specific user parameters
error message
warning
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017