Editing A Job List - HEIDENHAIN TNC 620 User Manual

Batch Process Manager | Batch Process Manager (option 154)

Editing a job list

There are two ways to create a job list:
In the pallet management
Further information:
The control opens the pallet table (.p) in the Batch Process
Manager as a job list.
Directly in the Batch Process Manager
You can edit a line in the job list in the Batch Process Manager as
follows:
Open the desired job list
Press the EDIT soft key
Place the cursor on the desired line, e.g. Pallet
The control displays the selected line in blue.
The control displays the editable entries on the
right-hand side.
Press the CHANGE WINDOW soft key if required
The control switches the active window.
The following entries can be changed:
Name
Datum table
Preset
Locked
Editing possible
Confirm the edited entries by pressing the ENT
key.
The control adopts the changes.
Press the EDIT soft key
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
"Editing pallet tables", page 604
15
617