HEIDENHAIN TNC 620 User Manual page 247

Tools | Tool data
Selecting a pocket table in Programming mode
Proceed as follows to select the pocket table in the Programming
mode of operation:
To call the file manager, press the PGM MGT key.
Press the SHOW ALL soft key
Select a file or enter a new file name
Confirm your entry with the ENT key or the
SELECT soft key
Abbr. Inputs
P
Pocket number of the tool in the tool magazine
T
Tool number
RSV
Pocket reservation for box magazines
ST
Special tool (ST); If your special tool blocks pockets in front of
and behind its actual pocket, these additional pockets need to
be locked in column L (status L).
F
The tool is always returned to the same pocket in the tool
magazine
L
Locked pocket (L: for Locked)
DOC
Display of the comment to the tool from TOOL.T
PLC
Information on this tool pocket that is to be sent to the PLC
P1 ... P5
Function is defined by the machine tool builder. The machine
tool documentation provides further information
PTYP
Tool type. Function is defined by the machine tool builder. The
machine tool documentation provides further information
LOCKED_ABOVE
Box magazine: Lock the pocket above
LOCKED_BELOW
Box magazine: Lock the pocket below
LOCKED_LEFT
Box magazine: Lock the pocket at left
LOCKED_RIGHT
Box magazine: Lock the pocket at right
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Dialog
-
Tool number?
Pocket reserv.: Yes =
ENT / No = NOENT
Special tool?
Fixed pocket? Yes =
ENT / No = NO ENT
Pocket locked Yes =
ENT / No = NO ENT
-
PLC status?
Value?
Tool type for pocket
table?
Lock the pocket
above?
Lock the pocket
below?
Lock the pocket at
left?
Lock the pocket at
right?
247
6