19.13 Firewall; Application - HEIDENHAIN TNC 620 User Manual

MOD Functions | Firewall

19.13 Firewall

Application

You can set up a firewall for the primary network interface of the
control. It can be configured so that incoming network traffic is
blocked and/or a message is displayed, depending on the sender
and the service. The firewall cannot be started for the second
network interface of the control if it is active as the DHCP server.
Once the firewall has been activated, a symbol appears at the
lower right in the taskbar. The symbol changes depending on the
safety level that the firewall was activated with, and informs about
the level of the safety settings:
Icon Meaning
Firewall protection does not yet exist
although it has been activated accord-
ing to the configuration. This can happen,
for example, if PC names for which there are
no equivalent IP addresses as yet were used
in the configuration.
Firewall active with medium security level
Firewall active with high safety level. (All
services except for the SSH are blocked)
Have your network specialist check and, if necessary,
change the standard settings.
The settings in the additional tab SSH settings are in
preparation for future enhancements and currently have
no function.
Configuring the firewall
Make your firewall settings as follows:
Use the mouse to open the task bar at the bottom edge of the
screen
Further information:
Press the green HEIDENHAIN button to open the JH menu
Select the Settings menu item
Select the Firewall menu item.
HEIDENHAIN recommends activating the firewall with the
prepared default settings:
Set the Active option to enable the firewall
Press the Set standard values button to activate the default
settings recommended by HEIDENHAIN.
Exit the dialog with the OK button.
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
"Window manager", page 100
19
763