Introduction | Modes of operation
Program Run, Full Sequence and Program Run, Single
Block
In the Program Run Full Sequence mode, the control executes
a program continuously to its end or to a manual or programmed
stop. You can resume program run after an interruption.
In the Program Run Single Block mode, you execute each block
separately by pressing the NC start key. With point pattern cycles
and CYCL CALL PAT the controls stops after each point.
Soft keys for selecting the screen layout
Soft key
Window
Program
Left: program, right: structure
Left: program, right: status display
Left: program, right: graphics
(option 20)
Graphic
(option 20)
Soft keys for screen layout with pallet tables(option 22 Pallet
management)
Soft key
Window
Pallet table
Left: program, right: pallet table
Left: pallet table, right: status display
Left: pallet table, right: graphics
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
2
93