HEIDENHAIN TNC 620 User Manual page 31

Fundamentals | Control model, software and features
The icons of basic rotation, 3-D basic rotation and tilted working
plane were modified to make them easier to distinguish, see
"General status display", page 94
The icon for FUNCTION TCPM was modified, see "General
status display", page 94
The control automatically recognizes whether a table is to be
imported or the table format is to be adapted, see "Importing
tool tables", page 243
When you place the cursor in an input field of the tool
management, the entire input field is highlighted.
When you double-click a selection field of the table editor with
the mouse or press the ENT key, a pop-up window opens.
When configuration subfiles are modified, the control no longer
aborts the test run, but only displays a warning.
You can neither set nor modify a preset without having
referenced the axes, see "Traverse reference points",
page 622
The control issues a warning if the handwheel potentiometers
are still active when the handwheel is deactivated, see "Traverse
with electronic handwheels", page 627
When using the HR 550 or HR 550FS handwheels, a warning
is issued if the battery voltage is too low, see "Traverse with
electronic handwheels", page 627
The machine tool builder can define whether the R-OFFS offset
will be taken into account for a tool with CUT 0, see "Tool
table: Tool data required for automatic tool measurement",
page 239
The machine tool builder configures whether the control
will take the axis angle into account or set it to 0 for the
axes specified in M138, see "Selecting tilting axes: M138",
page 571
The machine tool builder can change the simulated tool change
position, see "Test run", page 713
LN blocks are evaluated with a high accuracy, regardless of
option 23.
The SYSSTR function can be used to read the path of pallet
programs, see "Reading system data", page 448
In the machine parameter decimalCharakter (no. 100805) you
can define whether a period or a comma will be used as the
decimal separator, see "Machine-specific user parameters",
page 776
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
31