Comparison: Differences In Test Run, Functionality - HEIDENHAIN TNC 620 User Manual

Tables and Overviews | Functions of the TNC 620 and the iTNC 530 compared
Function
Programming minor axes:
Syntax FUNCTION PARAXCOMP:
Define the behavior of the
display and the paths of traverse
Syntax FUNCTION PARAXMODE:
Define the assignment of the
parallel axes to be traversed
Programming OEM cycles
Access to table data
Access to machine parameters
Creating interactive cycles with
CYCLE QUERY, e.g. touch probe
cycles in Manual Operation

Comparison: Differences in Test Run, functionality

Function
Entering a program with the GOTO
key
Calculation of machining time
Single block
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
TNC 620
Available
Available
Via SQL commands
and via FN 17/FN 18 or
TABREAD-TABWRITE functions
With the CFGREAD function
Available
TNC 620
Function only possible if the
START SINGLE soft key was not
pressed
Each time the simulation is repeat-
ed by pressing the START soft key,
the machining time is totaled
With point pattern cycles and CYCL
CALL PAT, the control stops after
each point
iTNC 530
Not available
Not available
Via FN 17/FN 18 or
TABREAD-TABWRITE functions
Via FN 18 functions
Not available
iTNC 530
Function also possible after
START SINGLE
Each time the simulation is repeat-
ed by pressing the START soft key,
time calculation starts at 0
Point pattern cycles and CYCL CALL
PAT are handled by the control as a
single block
20
825