HEIDENHAIN TNC 620 User Manual page 341

Data Transfer from CAD Files | CAD import (option 42)
Rapid selection of hole positions via icon
Select the mode for choosing machining
positions
The Graphics window is active for position
selection.
Select the icon
The control opens a pop-up window in which you
can filter the holes by size.
Configure the filter settings if required and press
the OK button to confirm
Further information:
page 342
The control loads the selected positions into the
List View window (displays a point symbol).
If necessary you can also deselect elements that
you already selected by clicking the element in
the Graphics window again, but this time while
pressing the CTRL key
Alternative: Select the element in the List View
window and press the DEL key
Alternative: Click the icon to deselect all selected
elements
Save the selected machining positions to the
clipboard of the control so that you can then
insert them as a positioning block with cycle call
in a Klartext program
Alternative: Save the selected machining
positions as a point file
The control displays a pop-up window in which
you can select the target directory, a file name,
and the file type.
Confirm the entry
The control saves the contour program to the
selected directory.
If you want to select more machining positions,
press the Cancel Selected Elements icon and
select as described above
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
"Filter settings",
8
341