HEIDENHAIN TNC 620 User Manual page 686

16
Finding the angle between the angle reference axis and a
workpiece edge
Select the probe function by pressing the
PROBING ROT soft key
Rotation angle: If you wish to restore the current
basic rotation later, note the value that appears
under Rotation Angle
Perform a basic rotation with the workpiece edge
to be compared
Further information:
misalignment with 3-D touch probe (option 17)",
page 669
Press the PROBING ROT soft key to display the
angle between the angle reference axis and the
workpiece edge as the rotation angle
Cancel the basic rotation, or restore the previous
basic rotation
Set the rotation angle to the value that you
previously wrote down
Measuring the angle between two workpiece edges
Select the probe function by pressing the
PROBING ROT soft key
Rotation angle: If you wish to restore the current
basic rotation later, note the value that appears
under Rotation Angle
Perform a basic rotation with the workpiece edge
to be compared
Further information:
misalignment with 3-D touch probe (option 17)",
page 669
Probe the second edge in the same way as for a
basic rotation, but do not set the rotation angle
to 0
Press the ROTATION PROBING soft key to display
the angle PA between the workpiece edges as
the rotation angle
Cancel the basic rotation, or restore the previous
basic rotation by setting the rotation angle to the
value that you wrote down previously
686
Manual Operation and Setup | Presetting with a 3-D touch probe (option number 17)
"Compensating workpiece
"Compensating workpiece
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017