Test Run Up To A Certain Block - HEIDENHAIN TNC 620 User Manual

18

Test Run up to a certain block

With the STOP AT function the control executes a Test Run up to
the block with block number N.
Proceed as follows to stop the Test Run at any block:
Press the STOP AT soft key
Stop at: N = Enter the block number at which
the simulation should stop
Program = Enter the name of the program
containing the block with the selected block
number
The control shows the name of the selected
program.
If the simulation is to be stopped in a program
that has been called using PGM CALL, then enter
this name
Repetitions = If N is located in a program section
repeat, enter the number of repeats that you
want to run.
Default 1: The control stops before N is
simulated
Possibilities in stopped condition
If you interrupt the Test Run with the STOP AT function, you have
the following possibilities in this stopped condition:
Block skip enable or disable
Optional program stop enable or disable
Modify graphics resolution and model
Modify the NC program in the Programming operating mode
If you modify the NC program in the Programming operating mode
the simulation behaves as follows:
Modification before the interruption point: The simulation
restarts at the beginning
Modification after the interruption point: Positioning at the
interruption point is possible with GOTO
716
Test Run and Program Run | Test run
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017