Free Straight Line Programming - HEIDENHAIN TNC 620 User Manual

Programming Contours | Path contours – FK free contour programming (option 19)

Free straight line programming

Straight line without tangential connection
To display the soft keys for free contour
programming, press the FK key
To initiate the dialog for free programming of
straight lines, press the FL soft key
The control displays additional soft keys.
Enter all known data in the block by using these
soft keys
The FK graphic displays the programmed contour
element in violet until sufficient data is entered.
If the entered data describes several solutions,
the graphic will display the contour element in
green.
Further information:
graphics", page 309
Straight line with tangential connection
If the straight line connects tangentially to another contour
element, initiate the dialog with the FLT soft key:
To display the soft keys for free contour
programming, press the FK key
To initiate the dialog, press the FLT soft key
Enter all known data in the block by using the
soft keys
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
"FK programming
7
311