HEIDENHAIN TNC 620 User Manual page 604

14
Pallet Management | Pallet management (option number 22)
Screen layout when working in the pallet table
If you want to see the NC program content and the content
of the pallet table at the same time, select the screen layout
PALLET + PROGRAM. During execution, the control then shows NC
program blocks to the left and the pallet to the right.
Editing pallet tables
If the pallet table is active in the Program run, full sequence
or Program run, single block operating mode, the soft keys for
modifying the table in the Programming operating mode are
inactive.
You can modify this table with the EDIT PALLET soft key in the
Program run, single block or Program run, full sequence
operating mode.
Block scan in a pallet table
With the pallet management you can also use the BLOCK SCAN
function in conjunction with pallet tables.
If you interrupt the processing of pallet tables, the control always
suggests the previously selected NC block of the interrupted NC
program for the BLOCK SCAN function.
Further information: "Block scan in pallet programs", page 732
604
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017