19
19.2 Graphic settings
With the MOD functions Graphic settings you can select the
model type and model quality operating mode.
To select Graphic settings proceed as follows:
Select the group Graphic settings from the MOD menu
Select the model type
Select the model quality
Press the APPLY soft key
Press the OK soft key.
In the Test Run operating mode, the control displays icons of the
active Graphic settings.
You have the following simulation parameters for the control's Graphic settings:
Model type
Icon
Model quality
Icon
740
Choice
Properties
3-D
Very true to detail,
heavy time and processor consump-
tion
2.5 D
Fast
No model
Very fast
Choice
Properties
Very high
High data transfer rate, exact depiction of tool geometry,
depiction of block end points and block numbers possible
High
High data transfer rate, exact depiction of tool geometry
Medium
Medium data transfer rate, approximation of tool geometry
Low
Low data transfer rate, coarse approximation of tool geometry
Application
Milling with undercuts,
Milling without undercuts
Line graphics
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
MOD Functions | Graphic settings