HEIDENHAIN TNC 620 User Manual page 785

Tables and Overviews | Machine-specific user parameters
Parameter settings
ChannelSettings
CH_NC
Active kinematics
Kinematics to be activated
List of machine kinematics
Kinematics to be activated with control start-up
List of machine kinematics
Determining the behavior of the NC program
Resetting the machining time with program start
True: Machining time is reset
False: Machining time is not reset
PLC signal for number of pending machining cycle
Dependent on machine manufacturer
Geometry tolerances
Permissible deviation of circle radius
0.0001 to 0.016 [mm]: Permissible deviation of circle radius on the circle end
point compared to circle start point
Permissible error in successive threads
Configuration of machining cycles
Overlap factor for pocket milling
0.001 to 1.414: Overlap factor for Cycle 4 POCKET MILLING and Cycle 5 CIRCU-
LAR POCKET
Behavior after machining a contour pocket
PosBeforeMachining: Position as before machining a cycle
ToolAxClearanceHeight: Position tool axis to clearance height
Display Spindle ?
on: Output error message
off: Do not output error message
Display Enter negative depth
on: Output error message
off: Do not output error message
Approach behavior on a slot wall in a cylindrical surface
LineNormal: Approach with straight line
CircleTangential: Approach with an arc movement
M function for spindle orientation in machining cycles
-1: Spindle orientation directly via NC
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
error message if M3/M4 is not active
error message
20
785