HEIDENHAIN TNC 620 User Manual page 645

Manual Operation and Setup | Managing presets
There are several methods for saving presets and basic rotations in
the preset table:
Manual input
Using the probing cycles in the Manual operation and
Electronic handwheel modes
Using probing cycles 400 to 402 and 410 to 419 in automatic
mode
Further information:
Operating notes:
Basic rotations from the preset table rotate the
coordinate system about the preset, which is shown
in the same row as the basic rotation.
When presetting, the positions of the tilting axes
must match the tilted situation.
If the Tilt working plane function is not active,
the position display for the rotary axes must be
= 0° (zero the rotary axes if necessary)
If the Tilt working plane function is active, the
position displays for the rotary axes must match
the angles entered in the 3-D ROT menu
PLANE RESET does not reset the active 3-D ROT.
In row 0 the control always saves the preset that
you most recently set manually via the axis keys or
via soft key. If the preset set manually is active, the
control displays the text PR MAN(0) in the status
display.
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Cycle Programming User's Manual
16
645