Removing The Pci Access Cover; Figure 2-8 Removing And Replacing The Pci Access Cover - Compaq ES40CSLP Installation, User & Service Manual

Installation

2.7 Removing the PCI Access Cover

_____________________________Caution__________________________
Use care when removing and replacing the cover to prevent damage to the RFI
gaskets that are located around the four sides of the cover.
______________________________________________________________
Perform the following procedure to remove the PCI access cover:
1. Extend the chassis for service (see Section 5.2).
2. Loosen the two captive screws
Figure 2-8).
3. Swing the front of the PCI access cover out from the chassis (see Figure 2-8).
4. Pull the PCI access cover forward until the rear edge
edge of the PCI card cage opening, and then pull the PCI access cover out and away from
the chassis.
To replace the PCI access cover, refer to Figure 2-8and reverse steps 1 through 4 of the
removal procedure.

Figure 2-8 Removing and Replacing the PCI Access Cover

2–12 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
™
along the front edge of the PCI access cover
›
of the cover comes out of the rear
3
2
1
EA-00066
š
(see