2.10 Installing Memory DIMMs
The ES40CSLP rackmount system contains four memory motherboards for installing memory
DIMMs. Each memory motherboard has eight slots for installing 200-pin DIMMs. A memory
set consists of four DIMMs. The system can be populated with a maximum of eight memory
sets, numbered 0 through 7. Figure 2-13 shows the memory motherboard slot locations on the
system motherboard and the memory set locations on the memory motherboards. The following
configuration rules apply to the memory sets:
•
DIMMs are installed in sets of four.
•
All DIMMs in a set must be the same size.
•
Two sets constitute an array. All DIMMs within an array must be the same size. For
example, if Set 0 consists of 64 MB DIMMs, Set 4 must also consist of 64 MB DIMMs.
The arrays are as follows:
Array 0
Array 1
Array 2
Array 3
•
DIMM sets must be installed in numerical order. Set 0 is installed first, then Set 1, Set 2,
Set 3, and so forth.
Figure 2-13 Memory Configuration
MMB 2
Array 1
Array 1
Array 1
Array 1
Sets 1 & 5
Sets 1 & 5
Sets 1 & 5
Sets 1 & 5
Array 3
Array 3
Array 3
Array 3
Sets 3 & 7
Sets 3 & 7
Sets 3 & 7
Sets 3 & 7
Array 0
Array 0
Array 0
Array 0
Sets 0 & 4
Sets 0 & 4
Sets 0 & 4
Sets 0 & 4
Array 2
Array 2
Array 2
Array 2
Sets 2 & 6
Sets 2 & 6
Sets 2 & 6
Sets 2 & 6
Perform the following procedure to install memory DIMMs:
1. Perform an orderly shutdown of the operating system.
Set 0 and Set 4
Set 1 and Set 5
Set 2 and Set 6
Set 3 and Set 7
Sets
6
6
4
4
2
2
0
0
MMB 0
MMB 3
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 2–17
Sets
7
7
5
Sets
5
3
6
3
6
1
4
1
4
2
2
0
0
MMB 1
EA-00071
Installation