Displaying The Hardware Configuration; Example 3-4 Show Boot - Compaq ES40CSLP Installation, User & Service Manual

When the operating system is running, the control panel displays the console revision. It is
useful to create a customized message if you have a number of systems and you want to
identify each system by a node name.
Use the SRM set ocp_text command to change this message. The message can be up to 16
characters and must be entered in quotation marks.
Example 3-3 Set ocp_text Command
P00>>> set ocp_text "Node Alpha1"

3.4.3 Displaying the Hardware Configuration

View the system hardware configuration for Tru64 UNIX and OpenVMS systems from the
SRM console. It is useful to view the hardware configuration to ensure that the system
recognizes all devices, memory configuration, and network connections.
Displaying a Tru64 UNIX or OpenVMS Configuration
Use the following SRM console commands to view system configuration for Tru64 UNIX or
OpenVMS systems. Additional commands to view the system configuration are described in the
Compaq AlphaServer ES40 User Interface Guide.
show boot*
show config
show device
show fru
show memory

Example 3-4 show boot *

P00>>>show boot*
boot_dev
boot_file
boot_osflags
boot_reset
bootdef_dev
booted_dev
booted_file
booted_osflags
Displays the boot environment variables.
Displays the logical configuration of interconnects and buses on the system
and the devices found on them.
Displays the bootable devices and controllers in the system.
Displays the physical configuration of FRUs (field-replaceable units). See
Chapter 6 for information on this command.
Displays configuration of main memory.
dka0.0.0.1.1
a
OFF
dka0.0.0.1.1
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 3–7
Operation