Table of Contents
Advertisement
Installation
2.4.2.2 Attaching the Left Slide Assembly to the Cabinet Rails
To attach the left slide assembly to the cabinet rails, refer to Figure 2-2 and proceed as follows:
1. Determine the proper mounting holes for the left slide brackets. The proper mounting holes
are the 11th, 12th, 13th and 14th holes of the installation area (see Figure 2-1).
2. Locate the left slide assembly and remove the inner race by extending the inner race to the
fully extended position and then pushing up on the locking lever and pulling the inner race
out of the slide assembly.
3. Place the left front slide bracket
the captive bar nut with two slide bracket holes and with the 11th and 13th holes of the
installation area on the left front rail.
4. Install two 10-32 screws
left front slide bracket to the left front rail, but do not tighten.
5. Place the left rear slide bracket
the captive bar nut with two slide bracket holes and with the 12th and 14th holes of the
installation area on the left rear rail.
6. Install two 10-32 screws
left rear slide bracket to the left rear rail, but do not tighten.
7. Tighten the two 8-32 screws and nuts that secure the left rear slide bracket to the left slide
assembly.
8. Securely tighten all four 10-32 screws that secure the left slide assembly to the left front
and rear cabinet rails.
2.4.3 Installing Rail Nuts on the Front Rails
Four rail nuts must be installed on the front cabinet rails to receive the front panel captive
screws that secure the system to the cabinet. Refer to Figure 2-2 and use the following
procedure to install the rail nuts:
1. Install a rail nut
rail by sliding the rail nut over the edge of the cabinet rail and aligning it with the hole.
Ensure that the threaded half of the rail nuts are toward the inside of the cabinet.
2. Install a rail nut
by sliding the rail nut over the edge of the cabinet rail and aligning it with the hole. Ensure
that the threaded half of the rail nuts are toward the inside of the cabinet.
2–6 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
on the inside of the left front rail and align two holes of
ž
in the 11th and 13th holes of the installation area to secure the
Ÿ
on the inside of the left rear rail and align two holes of
in the 12th and 14th holes of the installation area to secure the
¡
over the 2nd and 14th holes of the installation area on the right front
¢
over the 2nd and 14th holes of the installation area on the left front rail
Advertisement
Table of Contents
Troubleshooting
