Figure 2-14 Installing Memory Dimms - Compaq ES40CSLP Installation, User & Service Manual

Installation
2. Ensure that the power On/Off button on the OCP is in the Off position.
3. Extend the chassis for service (see Section 5.2).
4. Disconnect the power cord from the power supply ac input receptacle on the rear of the
chassis.
5. Remove the top cover (see Section 2.6).
6. Determine where the set of memory DIMMs should be installed (see Figure 2-13).
7. Put on an antistatic wriststrap.
_____________________________Caution__________________________
An antistatic wriststrap must be worn when handling any module to prevent
damage to the module.
______________________________________________________________
8. Remove the two memory motherboards on which the set of memory DIMMs are to be
installed (see Figure 2-14).
9. Open the locking levers on the two appropriate DIMM slots on each of the memory
motherboards (see Figure 2-14).
10. Align each DIMM with the appropriate slot and push firmly down until the DIMM is
properly seated and the locking levers have closed.
11. After installing the four DIMMs in the memory set, reinstall the two memory
motherboards (see Section 5.14).
After installing both memory motherboards, reverse steps 1 through 5 and reboot the system.
To verify the installation, observe the screen display during power-up to see if the amount of
memory in each array correctly appears in the display. Issue the show memory command from
the SRM console to display the total amount of memory in the system.

Figure 2-14 Installing Memory DIMMs

2–18 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
1
2
3
4
5
6
7
8
LJ-06626