Installing Pci Option Modules; Figure 2-15 Pci Backplane Layout - Compaq ES40CSLP Installation, User & Service Manual

2.11 Installing PCI Option Modules

Refer to Figure 2-15 for the layout of the PCI slots on the PCI backplane. The PCI backplane
has seven slots that are dedicated to PCI options.
___________________________ WARNING _________________________
For protection against fire, only modules with current limited output should
be used.
______________________________________________________________
___________________________ ACHTUNG _________________________
Zum Schutz gegen Feuer sollten nur Module mit begrenztem Ausgangsstrom
benutzt werden.
______________________________________________________________

Figure 2-15 PCI Backplane Layout

c
PCI bus 0
Perform the following procedure to install a PCI option module:
1. Perform an orderly shutdown of the operating system.
2. Ensure that the power On/Off button on the OCP is in the Off position.
3. Extend the chassis for service (see Section 5.2).
4. Disconnect the power cord from the ac input receptacle on the rear of the chassis.
5. Remove the PCI access cover (see Section 2.7).
6. Remove the filler panel screw and the blank filler panel
installing the PCI option module (see Figure 2-16). Save the filler panel screw for securing
the option module in place.
7
6
5
4
3
2
1
š
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 2–19
2
1
EA-00072
PCI bus 1
c
from the slot selected for
Installation