Show Error - Compaq ES40CSLP Installation, User & Service Manual

Troubleshooting and Diagnostics
-sv <mop_version>
-to <loop_time>
-w <wait_time>
Environment Variables
e*a*_loop_count
e*a*_loop_inc
e*a*_loop_patt
loop_size
Example Sequence
>>nettest
>>nettest ez*
>>nettest -mode ex
>>nettest -mode ex -w 10
>>nettest -f foo -mode nm -

6.6.2.13 show error

The show error command displays the SDD/TDD errors on the specified FRU.
Use the clear error command to clear SDD/TDD errors.
Syntax
show error <fruname>
Fruname is the name of the specified FRU. If you do not specify a fruname, all errors are
displayed.
6–40 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
Specifies which MOP version protocol to use. If 3, then MOP V3
(DECNET Phase IV) packet format is used. If 4, then MOP V4
(DECNET Phase V IEEE 802.3) format is used.
Specifies the time in seconds allowed for the loop messages to be
returned. The default is 2 seconds.
Specifies the time in seconds to wait between passes of the test.
The default is 0 (no delay). The network device can be very CPU
intensive. This option will allow other processes to run.
Specifies the number (hex) of loop requests to send. The default is
0x3E8 loop packets.
Specifies the number (hex) of bytes the message size is increased
on successive messages. The default is 0xA bytes.
Specifies the data pattern (hex) for the loop messages. The
following are legitimate values.
0 : all zeros
1 : all ones
2 : all fives
3 : all 0xAs
4 : incrementing data
5 : decrementing data
ffffffff : all patterns
Specifies the size (hex) of the loop message. The default packet
size is 0x2E.
internal loopback test on port ei*0 or ew*0
-
internal loopback test on ports eia0/eib0 or ewa0/ewb0
-
external loopback test on port eia0 or ewa0
-
external loopback test on port eia0 or ewa0; wait
-
10 seconds between tests
normal mode loopback test on port eia0 or ewa0
using the list of nodes contained in the file foo