Cd-Rom Drive; Figure 5-7 Removing And Replacing The Cd-Rom Drive - Compaq ES40CSLP Installation, User & Service Manual

5.8 CD-ROM Drive

Perform the following procedure to remove the CD-ROM drive:
1. Extend the chassis for service (see Section 5.2).
2. Remove the front panel (see Section 5.3).
3. Remove the removable media bracket (see Section 5.6).
4. Remove the five screws
together (see Figure 5-7).
5. Disconnect the flex cable connector
5-7).
6. Remove the four screws
removable media bracket (see Figure 5-7).
To replace the floppy drive, refer to Figure 5-7 and reverse steps 1 through 6 of the removal
procedure.

Figure 5-7 Removing and Replacing the CD-ROM Drive

1
c
that secure the two halves of the removable media bracket
š
from the rear of the CD-ROM drive (see Figure
›
that secure the CD-ROM drive to the bottom half of the
3
1
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 5–9
Removal and Replacement
2
3
EA-00083