Rmc Command-Line Interface - Compaq ES40CSLP Installation, User & Service Manual

4.7 RMC Command-Line Interface

The remote management console supports setup commands and commands for managing the
system.
The RMC commands are listed below.
clear {alert, port}
deposit
disable {alert, remote}
dump
enable {alert, remote}
env
halt {in, out}
hangup
help or ?
power {on, off}
quit
reset
send alert
set {alert, com1_mode, dial, escape, init, logout, password, user}
status
_____________________________ Note____________________________
The deposit and dump commands are reserved for service providers.
______________________________________________________________
For an RMC commands reference, see the Compaq AlphaServer ES40 User Interface Guide.
Command Conventions
Observe the following conventions for entering RMC commands:
•
Enter enough characters to distinguish the command.
_____________________________ Note____________________________
The reset and quit commands are exceptions. You must enter the entire string for
these commands to work.
______________________________________________________________
•
For commands consisting of two words, enter the entire first word and at least one letter of
the second word. For example, you can enter disable a for disable alert.
•
For commands that have parameters, you are prompted for the parameter.
•
Use the Backspace key to erase input.
•
If you enter a nonexistent command or a command that does not follow conventions, the
following message is displayed:
*** ERROR - unknown command ***
•
If you enter a string that exceeds 14 characters, the following message is displayed:
*** ERROR - overflow ***
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 4–7
Remote System Management