Top Cover; Figure 5-3 Removing And Replacing The Top Cover - Compaq ES40CSLP Installation, User & Service Manual

5.4 Top Cover

____________________________ Caution __________________________
Use care when removing and replacing the cover to prevent damage to the RFI
gaskets that are located around the cover and opening.
______________________________________________________________
Perform the following procedure to remove the top cover:
1. Extend the chassis for service (see Section 5.2).
2. Loosen the three captive screws
3. Lift the left edge of the cover and slide it to the left until the three tabs
of the top cover come out of the three slots
of the chassis.
To replace the top cover, refer to Figure 5-3 and reverse steps 1 through 3 of the removal
procedure.

Figure 5-3 Removing and Replacing the Top Cover

1
c
on the top left side of the top cover
2
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 5–5
Removal and Replacement
œ
in the chassis wall and lift the top cover off
3
4
EA-00065
š
(see Figure 5-3).
›
on the right edge