Hard Disk Drive - Compaq ES40CSLP Installation, User & Service Manual

5.10 Hard Disk Drive

Perform the following procedure to remove a hard disk drive:
1. Extend the chassis for service (see Section 5.2).
2. Remove the hard disk drive cover (see Section 5.9).
3. Disconnect the data
drive (see Figure 5-9).
4. Loosen the two captive screws
5. Pull the hard disk drive and bracket up and out of the hard disk drive bay.
6. Remove the two screws
on each side) of the hard disk drive (see Figure 5-9).
7. Remove the four screws
drive
8. Remove the four rubber grommets
the hard disk drive bracket
To replace the hard disk drive, refer to Figure 5-9 and reverse steps 1 through 8 of the removal
procedure.
and power
Ÿ
ž
that secure the two rubber grommets
œ
through the four rubber grommets that secure the hard disk
›
to the hard disk drive bracket (see Figure 5-9).
š
.
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 5–11
Removal and Replacement
¡
cables from the connectors on the top of the hard disk
on the top of the hard disk drive bracket (see Figure 5-9).
™
from the four slots on the sides (two on each side) of

to the lower sides (one