Installing An Optional Hard Disk Drive - Compaq ES40CSLP Installation, User & Service Manual

Installation

2.15 Installing an Optional Hard Disk Drive

The ES40CSLP rackmount system can contain two hard disk drives.
Perform the following procedure to install an optional hard disk drive:
1. Perform an orderly shutdown of the operating system.
2. Ensure that the power On/Off button on the OCP is in the Off position.
3. Extend the chassis for service (see Section 5.2).
4. Remove the hard disk drive cover (see Section 2.14).
5. Insert four rubber grommets
disk drive bracket
6. Secure the hard disk drive
four rubber grommets (see Figure 2-20).
7. Attach two rubber grommets
with two screws
8. Slide the hard disk drive and bracket into one of the two available positions and apply
pressure until the two rubber grommets, on the lower sides of the hard disk drive, slide into
the grommet holders at the bottom of the position.
9. Secure the hard disk drive and bracket into position with the two captive screws
top of the hard disk drive bracket (see Figure 2-20).
10. Connect the data
(see Figure 2-20).
After installing the hard disk drive, reverse steps 1 through 4 and reboot the system.
2–24 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
c
in the four slots on the sides (two on each side) of the hard
š
.
›
to the hard disk drive bracket with four screws

to the lower sides (one on each side) of the hard disk drive
ž
(see Figure 2-20).
¡
and power cables to the connectors on the top of the hard disk drive
œ
through the
Ÿ
on the