Access Panel; Removing The Server Blade Access Panel - Compaq ProLiant BL20p Maintenance And Service Manual

Removal and Replacement Procedures

Access Panel

To remove the access panel:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blade Preparation" section in this chapter.
2. Loosen the thumbscrew (1).
3. Press down on the thumb indentations, slide the access panel toward the rear of the unit
about 1.25 cm (0.5 in), and lift to remove the panel (2).
Figure 2-3: Removing the server blade access panel
Reverse steps 1 through 3 to replace the access panel.
2-6
COMPAQ CONFIDENTIAL Codename: AvalancheX Part Number: 316080-001 Last Saved On: 12/18/02 11:31 AM
1
Compaq ProLiant BL20p Server Blade Maintenance and Service Guide
2
2