Front Or Rear Emi/Rfi Honeycomb Filter; Figure 5-16 Removing And Replacing The Front Or Rear Emi/Rfi Honeycomb Filter Assembly - Compaq ES40CSLP Installation, User & Service Manual

5.17 Front or Rear EMI/RFI Honeycomb Fil ter
Perform the following procedure to remove the front or rear EMI/RFI honeycomb filter:
1. Extend the chassis for service (see Section 5.2).
2. Remove the top cover (see Section 5.4).
3. Remove the CPU modules (see Section 5.13).
4. Remove the two screws
Figure 5-16).
5. Lift the EMI/RFI honeycomb filter assembly until the three tabs
EMI/RFI honeycomb filter assembly come out of the three slots in the chassis (see Figure
5-16).
6. Remove the EMI/RFI honeycomb filter element
assembly (see Figure 5-16).
To replace a front or rear EMI/RFI honeycomb filter, refer to Figure 5-16 and reverse steps 1
through 6 of the removal procedure. Ensure that the three tabs on the bottom of the assembly go
into the three slots in the chassis and that the EMI/RFI gasket on the replacement EMI/RFI
honeycomb filter element is toward the outside of the chassis.
Figure 5-16 Removing and Replacing the Front or Rear EMI/RFI Honeycomb
Filter Assembly
4
c
along the top of the EMI/RFI honeycomb filter assembly
2
1
1
2
3
3
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 5–19
Removal and Replacement
›
on the bottom of the
œ
from the EMI/RFI honeycomb filter
4
EA-00088
š
(see