Compaq ES40CSLP Installation, User & Service Manual page 142

Troubleshooting and Diagnostics
initializing idle process PID
lowering IPL
CPU 2 speed is 2.22 ns (500MHz)
create powerup
entering idle loop
starting console on CPU 3
initialized idle PCB
initializing idle process PID
lowering IPL
CPU 3 speed is 2.22 ns (500MHz)
create powerup
initializing GCT/FRU at offset 17a000
AlphaServer ES40 Console X5.4-236, built on Mar
P00>>>
c
š
›
œ
{

ž
6–16 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
The primary CPU prints a message indicating that it is running the console. Starting with
this message, the power-up display is printed to any console terminal, regardless of the
state of the console environment variable.
If console is set to graphics, the display from this point to the end is saved in a memory
buffer and printed to the VGA monitor after the PCI buses are sized and the VGA device is
initialized.
The memory size is determined and memory is tested.
The I/O subsystem is probed and I/O devices are reported. I/O adapters are configured.
Device drivers are started.
The console saw that CPU 1 did not power up and fans 1 and 2 failed.
The console is started on the secondary CPUs.
Systems running Tru64 UNIX or OpenVMS display the SRM console banner and the
prompt, Pnn>>>. The number n indicates the primary processor. In a multiprocessor
system, the prompt could be P00>>>, P01>>>, P02>>> and so on. From the SRM prompt,
you can boot the Tru64 UNIX or OpenVMS operating system.
ž
5 1999 at 01:42:13