Memory Dimms; Figure 5-14 Removing And Replacing Memory Dimms - Compaq ES40CSLP Installation, User & Service Manual

5.15 Memory DIMMs

Perform the following procedure to remove memory DIMMs:
1. Extend the chassis for service (see Section 5.2).
2. Remove the top cover (see Section 5.4).
3. Remove the memory motherboard (see Section 5.14).
4. Put on an antistatic wriststrap.
____________________________ Caution __________________________
An antistatic wriststrap must be worn when handling any module to prevent
damage to the module.
______________________________________________________________
5. Push out on the locking levers
removed (see Figure 5-14).
6. Pull the memory DIMM
To replace the memory DIMM, refer to Figure 5-14 and align the memory DIMM with the
appropriate slot and push firmly down until the DIMM is properly seated and the locking levers
have closed. After replacing the memory DIMMs, reverse steps 1 through 3 of the removal
procedure.

Figure 5-14 Removing and Replacing Memory DIMMs

c
located on each end of the memory DIMM
š
straight up out of its slot (see Figure 5-14).
1
2
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 5–17
Removal and Replacement
š
1
LJ-06663
being