Table of Contents
Advertisement
5.21 Miscellaneous I/O Module
Perform the following procedure to remove the miscellaneous I/O module:
1. Extend the chassis for service (see Section 5.2).
2. Remove the PCI access cover (see Section 5.5).
3. Disconnect any cables that are connected to the miscellaneous I/O module and the Ethernet
connector from the rear of the chassis.
4. Disconnect the ribbon cable
5. Remove the four screws
and slide the bracket out of the rear of the chassis (see Figure 5-20).
6. Remove the six standoffs
miscellaneous I/O module to the rear of the miscellaneous I/O module bracket (see Figure
5-20).
7. Unsnap the miscellaneous I/O module
miscellaneous I/O module bracket
To replace the miscellaneous I/O module, refer to Figure 5-20 and reverse steps 1 through 7 of
the removal procedure.
Figure 5-20 Removing and Replacing the Miscellaneous I/O Module
c
from the miscellaneous I/O module (see Figure 5-20).
š
that secure the miscellaneous I/O module bracket to the chassis
›
with a 5 mm nutdriver and the two screws
ž
(see Figure 5-20).
4
2
1
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 5–23
Removal and Replacement
from the standoffs and remove it from the
2
3
5
6
EA-00091
œ
that secure the
Advertisement
Table of Contents
Troubleshooting
