Copying Function (Console Only) - Panasonic minas a4 series Instruction Manual

Copying Function (Console Only)

Copying of Parameters from the Driver to the Console
Operation at SELECTION display
Starting from initial LED status, Press
then press , to make a display to
Operation at EXECUTION display
Press to call for
EXECUTION DISPLAY of
Keep pressing until
the console display (LED)
changes to
Initialization of EEPROM
of the console starts.
Copying of parameters
from the driver to the console starts.
Writing of parameters
into the console EEPROM starts.
After copying finishes, return to SELECTION display, referring to structure of each mode (P.60 and 61)
<Remarks>
Don't disconnect the console from the driver between
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector,
misoperation due to noise or failure of console.
five time after pressing
Numeral decreases
• • • • •
as time passes.
Copying completes normally.
,
" " increases by
pressing (approx. 3sec)
as the left fig. shows.
<Remarks>
If error is displayed, repeat
the procedures from the
beginning.
Press
to
[Preparation]
Error display
for releasing error.
79